If the RS5100 stops responding to input, reset it. There are three reset functions, warm boot, cold boot and clean
boot. Perform a warm boot first. If the RS5100 still does not respond, perform a cold boot. Perform clean boot to
restore the RS5100 to its factory default configuration.

Warm Boot
To perform warm boot, press and hold the Restore Key for more than three seconds and then release. The
RS5100 resets when the key is released.

Cold Boot
Cold boot restores the RS5100 operation by performing a power cycle of the device. To perform cold boot, remove
and re-insert the battery into the RS5100.

Clean Boot
Clean Boot restores the RS5100 to its factory default configuration.
To perform clean boot:
1. Make sure the battery is inserted and the scanner is turned on.
2. Press and hold the Restore Key until the System LED turns on white.
3. Release the Restore Key and immediately press and hold the Restore Key.
4. Continue to hold the Restore Key until two beeps indicating a Clean Boot are heard and the scanner boot beep
sequence is heard. The RS5100 is now in its factory default configuration.